Published at Monday, September 24th 2018. by Suzanne Giles in Patio Table.
Painting a worn plastic chair in a new table that was just purchased using pylons fusion for plastics spray paints. This project can be completed in three to four easy steps. The project materials you will need are a bucket of warm soapy water. A scrub brush mineral spirits and a rag, Fusion, satin, espresso, and feud and clear for best results, remove all the dirt and mildew from the worn chair using a scrub brush and warm soapy water. Remove all contaminants after cleaning.
If mildew is present, use a mixture of bleach and water to remove heavy mildew stains to prepare the new table, wipe down entire surface with mineral spirits and let dry mineral spirits is only needed to prepare new plastic surfaces prior to painting once all dirt and mildew Is removed, rinse surfaces and let dry you can rinse with a hose or with clean water after you, rinse allow the surface to thoroughly dry before beginning the next step. If you are painting a surface that has previously been painted, you also want to make sure it is clean, dull and dry lightly, and a glossy surface for best results following steps one and two once the surface is clean, dull and dry.
You are ready to begin painting with fusion. No priming is necessary, shake the can for one to two minutes to insure. The paint is mixed properly set the easy touch, 360 spray dial, so the spray comes out vertically and then spray the seat of the chair. From left to right, you can find more information on the easy touch 360 settings on the back of the label.
It is best to stop spraying after each pass doing this will minimize runs and drips pays entire surface. If additional coats are desired, you can apply as many as you wish within 24 hours, or wait seven days for the paint to store wait. One to two minutes between each coat huge clear is recommended over unpainted plastic for glossed durability and UV protection. Here we're applying huge increase espresso, apply fusion clear within four hours of applying the espresso or wait 24 hours. You may notice the milky appearance at first, but it will become clear as it dries spray.
The fusion clear, over the entire surface for best results and gloss, apply four to six thin coats waiting one minute between each. If additional coats are desired, you can apply as many as you wish within four hours, or wait 24 hours for their paint to store. If you do not use the entire can of paint make sure you clear the valve by turning the can upside down and spray for three to five seconds to clear the valve, otherwise, the paint in the tube may clog, making it hard to spray again with a little work time and very little money, we were able to turn this chair and table into a beautiful piece of patio furniture.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 cbtexplained.com. All Rights Reserved.