Published at Friday, September 28th 2018. by Delia James in Storage Bench.
We're going to do it in don't worry this altar table we're going to be using some redwood and we're choosing some they're nice for the tabletop and also some pressure-treated wood that we are going to be using for The frame of the table so now we've laid out our seven planks and we made our selection based on the color and the characters and what we want. Our final table to look like make sure. When you're laying out the planks that you put the growth ring facing down that way, if it rains in the water hits the table, the water will go off to the side. Oh now, we've flipped all of our signs overs make sure that you keep your outside edge, nice and smooth, but you don't want any knots on the outside all right. Our first cut with our long skirt here and we wanted to leave enough space on the end.
So that we'll have room for our legs, we're using stainless steel screws and because regular metal screws could react with the Redwood and leave a stain, and that would be in next. We use the scrap wood to make a little jig with a 1 inch of paper. So that way, as we were screwing it, we slid that down the way and made sure that we were really consistent with our safety. The last thing we did was use this handy-dandy Kreg jig on the end here and basically it makes some pocket screws there so that when we put the leg on the end, you won't be able to see the screw holes, so we glued it and we screwed it. The sucker should be on tight here we have the flat 4 underneath the tabletop.
We cut six pieces of one by three and right now, I'm making these pocket holes they're going to be attaching the slabs to the skirt of the table. You just attached our six blasts across the table. We use the board on the end, to make sure that our edge was flush and we use shims so that we could keep the spacing consistent. You want to make sure and keep a gap between the boards. So that the rain can go through and we use those pocket holes we made earlier to attach our glass to the skirt.
We just finished putting ten screws for every flat. That's sixty screws! Is it happy hour. Yet we passed our leg frame to the table using two screws in the pocket hole here on either side and then we go to through airplane all the way across. We put these little white feet on the ends. That way, it would keep the table off the floor.
Please make it quick here we are making our lag frame and what we did is we not lag the lag post so that the support which is the short skirt, can stitch right. There we put a little bit of a profile there. We respect some holes for these screws, they're going to be screwed in here two of this purpose and we pre-drilled to void and splinters you. Okay, now we're ready for the final cut. What I'm going to do here is, I have a straight edge.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 cbtexplained.com. All Rights Reserved.