Published at Sunday, 02 September 2018. Storage Bench. By Glenna Silva.
So let's go ahead and get started, so I built this project out of eight quarters, hard, maple and oak, but you could also just use a mix of one by twos and one by threes from your local home center. If you don't have the equipment to mill rough lumber, it was a ton of work ripping down the maple strips and I would have just bought the lumber already milled. If I didn't already have the maple on hand, I rip the maple into three-quarter inch by inch and a half strips on the table saw and if you're, using one by twos you'll want to purchase seven eight foot long
I built three of these benches in total. So that's why you see me gluing up so many pieces here. What the pieces cut the size. It was time to cut the data hose into the pieces. To do this, I made a little jig using a scrap piece of plywood. I set up my dado stack to be the exact width of the slats 3/4 of an inch in my case and then set the height to exactly half of the height of this flat, which is also 3/4 of an inch once this was set. I cut one path into the temporary fence and then added a small off cut from the slats to this. Opening. This off cut will serve as a stop block on the jig.
One by twos for the bench top and cut them into 48 inch long pieces once I mailed the maple into strips, I cut two of the strip's into 24 inch long sections and these short sections make up the horizontal cross members that run at each end and in the middle of the bench, top the middle cross member is twice as wide as you can see here, so I also glued up a pair of these cross members.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 cbtexplained.com. All Rights Reserved.