Published at Thursday, 06 September 2018. Storage Shed. By Elisa Glover.
Now we're going to bend the panel. But you'll need to tilt it slightly to get it in front of the right rear wall panel position. The two tabs at the bottom of a panel over the slots in the floor and push down or pull down on the panel to snap the two tabs into the slots, secure the panels together. The screws repeat this step, or these steps for the left rear corner panel now insert the three tabs at the bottom of the right front corner panel into the slots along the right edge of the floor assembly slide the panel towards the rear and secure the panels With screw repeat this step for the left front corner panel then tip the assembly on his backside. Now take the two vertical support tubes and attach them by sliding one tube over the other and ensure the hole in the center is facing up pull the front quarter.
Now, with this support channel you'll notice that there are eight holes, but only four the holes are used in this step, now set a support channel into the groove along the back of the edge of the left door and align the holes secure this channel using six Screws there are six holes in this channel that model six holes are used in this step, turn the door over on its backside, align the holes and hinge with the divots on the side of the door. Note the Shat ford side of the holes must face away from the door now insert two screws: the holes in the inch, the door and through the two holes in the support channel on the back of the door. Repeat this step for the second inch now flip the door on its back and it's chance to handle pieces to the door using the required hardware.
Panel you'll know there's three tabs along the bottom of that bottom edge of that panel you're, going to stick those tabs in the third fourth and fifth slots from the right rear corner of the floor assembly now slide. The panel to the left take the second rear wall panel and insert the tabs at the bottom ave it into the third fourth and fifth slots from the rear, left corner of the floor assembly and slide this panel to the right. So it's two panels aligned right. Next to each other, now the board of the left panel goes behind the right panel. Secure the two panels, together with screws, now take a rear corner panel and insert the tabs at the bottom of it into the first two slots at the right, rear corner of the floor panel assembly and slide the panel forward.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 cbtexplained.com. All Rights Reserved.