Published at Thursday, 06 September 2018. Storage Shed. By Elisa Glover.
Now, let's work on the right door slide the scored tube into the hole at the bottom of the right door until it hangs out about six inches insert the end cap into the end of the tube and gently push the tube into the door until the cap Is flush with the bottom of the door use an electric drill to insert a self drilling screws to secure the tube in place. This step cannot be performed with a hand.Screwdriver align the four holes in this support channel with those in the right door. Secure the channel using four screws discard the retainer ring around the lock and use the key to lock. The locks of the latch is extended, align the latch with the depression in the latch knob and insert the lock into the knob position the latch. So it faces the bottom of the door and secure the lock assembly to the door. Using the hardware provided do not over tighten now insert the knob on the latch button up through the hole in the latch plate.
Use a 1/2 inch socket to push push nut onto the tighten securely then insert the curved end of the latch rod through the hole in the latch plate set. The latch spacer onto the locking mechanism place the latch plate onto the spacer. Note the hole in this spacer is for manufacturing purposes, only secure the latch plate to the locking mechanism using the two screws and secure the two rod guides to the door to hold the latch rod in place attach the handle pieces to the door using the required Hardware, this step is similar to the same step for the left door flip the door. So it's face up and align the holes in the hinge with the divots on the side of the door. Note the shat ford side of the holes must face away from the door, insert two screws with the holes and hinge the door and through the two holes in the support channel on the back of the door.
So the corners are at 90 degrees. Then tighten the screws now use an electric drill to insert a self drilling screw into the tubes. At the location shown it's okay, if there's a space between the tubes, it's important, the corners are square. Finally, insert a self drilling screws into each side of the tube assembly and into the small section the front corner panels. Again, you must use an electric drill to insert these self drilling screws in this instructional video, with some of the left and right doors of a lifetime horizontal shed, we'll start by laying the left door face down on a flat surface, set a support channel into the groove Along the back of the edge of the left door and align the holes secure this channel using four screws.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 cbtexplained.com. All Rights Reserved.