Published at Thursday, 06 September 2018. Storage Shed. By Elisa Glover.
Panels inward and insert the tube assembly into the holes in the bottom of the floor and into the front corner wall panels slide the tubes into the paddles until they hang out about six inches, ensure the corners of the tube assembly are square and use an electric Drill to insert a self drilling screw into the tubes to secure them together. Note this step cannot be done with a hand screwdriver, it's okay. If there's a space between the tubes, it's important, the corners are square finish: sliding the tube assembly into the corner wall panels. Now attach the two horizontal support tubes turn the shut up right and place the support tube assembly down into the shed and line the holes in the tubes with those in the wall panels, first insert the screws for the tubes and into the left and right walls. Next align the holes in the tubes with those in the rear wall panels and loosely insert the six screws adjust the rear tube.
So the corners are at 90 degrees. Then tighten the screws now use an electric drill to insert a self drilling screw into the tubes. At the location shown it's okay, if there's a space between the tubes, it's important, the corners are square. Finally, insert a self drilling screws into each side of the tube assembly and into the small section the front corner panels. Again, you must use an electric drill to insert these self drilling screws in this instructional video, with some of the left and right doors of a lifetime horizontal shed, we'll start by laying the left door face down on a flat surface, set a support channel into the groove Along the back of the edge of the left door and align the holes secure this channel using four screws.
Use a 1/2 inch socket to push push nut onto the tighten securely then insert the curved end of the latch rod through the hole in the latch plate set. The latch spacer onto the locking mechanism place the latch plate onto the spacer. Note the hole in this spacer is for manufacturing purposes, only secure the latch plate to the locking mechanism using the two screws and secure the two rod guides to the door to hold the latch rod in place attach the handle pieces to the door using the required Hardware, this step is similar to the same step for the left door flip the door. So it's face up and align the holes in the hinge with the divots on the side of the door. Note the shat ford side of the holes must face away from the door, insert two screws with the holes and hinge the door and through the two holes in the support channel on the back of the door.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 cbtexplained.com. All Rights Reserved.