Published at Thursday, 06 September 2018. Storage Shed. By Elisa Glover.
Now, with this support channel you'll notice that there are eight holes, but only four the holes are used in this step, now set a support channel into the groove along the back of the edge of the left door and align the holes secure this channel using six Screws there are six holes in this channel that model six holes are used in this step, turn the door over on its backside, align the holes and hinge with the divots on the side of the door. Note the Shat ford side of the holes must face away from the door now insert two screws: the holes in the inch, the door and through the two holes in the support channel on the back of the door. Repeat this step for the second inch now flip the door on its back and it's chance to handle pieces to the door using the required hardware.
Use a 1/2 inch socket to push push nut onto the tighten securely then insert the curved end of the latch rod through the hole in the latch plate set. The latch spacer onto the locking mechanism place the latch plate onto the spacer. Note the hole in this spacer is for manufacturing purposes, only secure the latch plate to the locking mechanism using the two screws and secure the two rod guides to the door to hold the latch rod in place attach the handle pieces to the door using the required Hardware, this step is similar to the same step for the left door flip the door. So it's face up and align the holes in the hinge with the divots on the side of the door. Note the shat ford side of the holes must face away from the door, insert two screws with the holes and hinge the door and through the two holes in the support channel on the back of the door.
We'll assemble the floor and walls of a lifetime horizontal shed we're going to lay the first floor panel flat on the ground. This is a left floor panel when you're facing the shed and place the second floor panel at an angle against it. So the tabs in the second floor panel interlock with the tabs on the first slide, the tabs on the second panel underneath the first panel and then lay that panel flat. Now we're going to insert two screws into the divots in the floor panels to secure them. Together note that these screws do not anchor the shed to the ground, they simply hold the floor panels together during assembly now take a rear wall.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 cbtexplained.com. All Rights Reserved.