Published at Thursday, 06 September 2018. Storage Shed. By Elisa Glover.
Now, with this support channel you'll notice that there are eight holes, but only four the holes are used in this step, now set a support channel into the groove along the back of the edge of the left door and align the holes secure this channel using six Screws there are six holes in this channel that model six holes are used in this step, turn the door over on its backside, align the holes and hinge with the divots on the side of the door. Note the Shat ford side of the holes must face away from the door now insert two screws: the holes in the inch, the door and through the two holes in the support channel on the back of the door. Repeat this step for the second inch now flip the door on its back and it's chance to handle pieces to the door using the required hardware.
So the corners are at 90 degrees. Then tighten the screws now use an electric drill to insert a self drilling screw into the tubes. At the location shown it's okay, if there's a space between the tubes, it's important, the corners are square. Finally, insert a self drilling screws into each side of the tube assembly and into the small section the front corner panels. Again, you must use an electric drill to insert these self drilling screws in this instructional video, with some of the left and right doors of a lifetime horizontal shed, we'll start by laying the left door face down on a flat surface, set a support channel into the groove Along the back of the edge of the left door and align the holes secure this channel using four screws.
Panel you'll know there's three tabs along the bottom of that bottom edge of that panel you're, going to stick those tabs in the third fourth and fifth slots from the right rear corner of the floor assembly now slide. The panel to the left take the second rear wall panel and insert the tabs at the bottom ave it into the third fourth and fifth slots from the rear, left corner of the floor assembly and slide this panel to the right. So it's two panels aligned right. Next to each other, now the board of the left panel goes behind the right panel. Secure the two panels, together with screws, now take a rear corner panel and insert the tabs at the bottom of it into the first two slots at the right, rear corner of the floor panel assembly and slide the panel forward.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 cbtexplained.com. All Rights Reserved.