Published at Thursday, 06 September 2018. Storage Shed. By Elisa Glover.
So the corners are at 90 degrees. Then tighten the screws now use an electric drill to insert a self drilling screw into the tubes. At the location shown it's okay, if there's a space between the tubes, it's important, the corners are square. Finally, insert a self drilling screws into each side of the tube assembly and into the small section the front corner panels. Again, you must use an electric drill to insert these self drilling screws in this instructional video, with some of the left and right doors of a lifetime horizontal shed, we'll start by laying the left door face down on a flat surface, set a support channel into the groove Along the back of the edge of the left door and align the holes secure this channel using four screws.
Panel you'll know there's three tabs along the bottom of that bottom edge of that panel you're, going to stick those tabs in the third fourth and fifth slots from the right rear corner of the floor assembly now slide. The panel to the left take the second rear wall panel and insert the tabs at the bottom ave it into the third fourth and fifth slots from the rear, left corner of the floor assembly and slide this panel to the right. So it's two panels aligned right. Next to each other, now the board of the left panel goes behind the right panel. Secure the two panels, together with screws, now take a rear corner panel and insert the tabs at the bottom of it into the first two slots at the right, rear corner of the floor panel assembly and slide the panel forward.
Now, let's work on the right door slide the scored tube into the hole at the bottom of the right door until it hangs out about six inches insert the end cap into the end of the tube and gently push the tube into the door until the cap Is flush with the bottom of the door use an electric drill to insert a self drilling screws to secure the tube in place. This step cannot be performed with a hand.Screwdriver align the four holes in this support channel with those in the right door. Secure the channel using four screws discard the retainer ring around the lock and use the key to lock. The locks of the latch is extended, align the latch with the depression in the latch knob and insert the lock into the knob position the latch. So it faces the bottom of the door and secure the lock assembly to the door. Using the hardware provided do not over tighten now insert the knob on the latch button up through the hole in the latch plate.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 cbtexplained.com. All Rights Reserved.