Published at Thursday, 06 September 2018. Storage Shed. By Elisa Glover.
Now, let's work on the right door slide the scored tube into the hole at the bottom of the right door until it hangs out about six inches insert the end cap into the end of the tube and gently push the tube into the door until the cap Is flush with the bottom of the door use an electric drill to insert a self drilling screws to secure the tube in place. This step cannot be performed with a hand.Screwdriver align the four holes in this support channel with those in the right door. Secure the channel using four screws discard the retainer ring around the lock and use the key to lock. The locks of the latch is extended, align the latch with the depression in the latch knob and insert the lock into the knob position the latch. So it faces the bottom of the door and secure the lock assembly to the door. Using the hardware provided do not over tighten now insert the knob on the latch button up through the hole in the latch plate.
Now we're going to bend the panel. But you'll need to tilt it slightly to get it in front of the right rear wall panel position. The two tabs at the bottom of a panel over the slots in the floor and push down or pull down on the panel to snap the two tabs into the slots, secure the panels together. The screws repeat this step, or these steps for the left rear corner panel now insert the three tabs at the bottom of the right front corner panel into the slots along the right edge of the floor assembly slide the panel towards the rear and secure the panels With screw repeat this step for the left front corner panel then tip the assembly on his backside. Now take the two vertical support tubes and attach them by sliding one tube over the other and ensure the hole in the center is facing up pull the front quarter.
Now, with this support channel you'll notice that there are eight holes, but only four the holes are used in this step, now set a support channel into the groove along the back of the edge of the left door and align the holes secure this channel using six Screws there are six holes in this channel that model six holes are used in this step, turn the door over on its backside, align the holes and hinge with the divots on the side of the door. Note the Shat ford side of the holes must face away from the door now insert two screws: the holes in the inch, the door and through the two holes in the support channel on the back of the door. Repeat this step for the second inch now flip the door on its back and it's chance to handle pieces to the door using the required hardware.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 cbtexplained.com. All Rights Reserved.