Published at Saturday, 01 September 2018. Storage Bench. By Olga Rivas.
I wanted to create some simple art design, leaving two and a half inches on either side. I draw an arc using the sanding disc. Then I cut out the design using the jigsaw. I repeat the same step for the longer sides now to attach the base. I use glue and brad means it held up everything together, really strong for the back. I did not use any art design and I attach the sides with some screws to create the back and the armrests. I cut some pinewood, then countersunk and attached it to the top with screws for the armrests. I curved the edges.
I flip the bench to attach the 6mm sheet to the back. then, by slowly tapping I remove the rest of the material. If the chisel is sharp, then you can remove words with just your hand. I can now place the hinge and mark the holes required. I transfer the placement measurements of the hinges to the door. I asked Lenin to help me with holding the doors. Then I was able to attach the door to the bench with a little bit of sanding on the sides, the door closed properly. Moving on to create the base, I ripped some plywood.
This is important only then you will get clean cut, then using a straightedge, I break the laminate at the score line. I use good amount of spray adhesive to attach the laminate using a cloth and pressure. I push out the air bubbles for the sides.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 cbtexplained.com. All Rights Reserved.