Published at Tuesday, September 25th 2018. by Janie Mills in Storage Bench.
Entryway bench from a single sheet of plywood. So when you get done watching this, video don't forget to check out all the other priority projects on the playlist in the video description below and don't forget to check out. The full tutorial for this crowded will disappear. Image building is also in the description below. So are you ready? Let's get started to start this project? A first cut, my plywood down to size. You can see exact dimensions in the blog post in the description below I cut a piece off the side of the faux wood for the drawers, and then I cut two side panels off the rest of the remaining plywood I just set my table saw and cut both of these side panel pieces to the exact same width once I had my two side panels cut.
I marked where the where I wanted at the top of the business seat to go, and then I used some round objects and kind of free handed the design that I wanted to go on the side of the bench. Once I had the design drawn, I cut it out with a jigsaw and ended everything. Then I went back to the table saw and I cut my top and my bottom finish see. I made sure they were the exact same width, just as I did with the side panels once they were cut.
I drove pocket holes into both ends of the top and the bottom bench. I attached the two side panels by screwing in the bottom. In the top inch seat, I used pocket hole, screws to screw the bottom of inch seat in first and then the top, and then I flip it over and attach the exact same way to the other side. Once these pieces were attached to the excellent, a divider in that I'd already hell, you can attach it, you can pop a hoers.
Then it was time to attach the top piece after I rip this piece on the table saw I cut it down to sizes in the miter saw to make sure it was sanded release. Once with these was sanded hydro pocket holes in both ends and along the bottom side of, I attached using froggy holes and screws from the back side making sure everything is really flush, and it was time to cut yours. I couldn't bear even then the long piece of plywood that I cut off the very beginning. Once I had the room cut, I cut everything down decides to use a miter saw and then I attach the floor pieces. They say pocket holes in screws.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 cbtexplained.com. All Rights Reserved.