Published at Thursday, 06 September 2018. Storage Shed. By Marta Woodward.
The three sides that touch the shed walls and floor will have an overhang of one and 1/4 inches. The side that touches the secondary door will have an overhang of one and a half inch after the two doors are made. You should lay them next to each other and verify the overhangs and overall sizes. The fourth step is to attach the door trim pieces cut out the trim pieces and check that they will fit together on the front of the doors, make sure that the screws are located so that they incur into the door rails behind the siding use a screw. At each end of each trim piece and then spaced evenly at 12 to 16 inches apart, any trim pieces in the center of the door panel will need to have their screws angled so that they hit the inner door.
This step takes several adjustments to make sure the overhangs and reveals are all equal attach the panel to the rails, using one and five-eighths inch screws install one screw at each rail end and in the center the trim screws will increase the attachment strength when the trim Is installed remember that there is a one and a quarter inch reveal, so the screws will need to be at least an inch and a half from the panel edges be careful not to install them so far in from the edge that the trim boards will not Cover them, the third step is to build the main operable door.
It is built similar to the secondary door, except that the front panel overhangs on all sides. This allows it to overlap the secondary door to create a more weather, tight, fit and finish use the same screw sizes and placements that you did on the other door. You made the main door front. Panel. Overhangs are different from the secondary door that you built previously.
Following the layout pattern shown on the door, plans set the back panel on the rails and make the outer edges of the rails flush with the edge of the panel screw the panel to the rails, using a 1 and 5/8 inch screw at 12 inches on center. The second step is to attach the front panel to the rail and back panel assembly. You just made start by flipping the door over and setting the front panel on. It use a tape measure to measure and adjust the front panel until the overhang is one and a quarter inches on the three sides that will be adjacent to the walls and floor on the fourth side, that is, between the two doors, the front panel will be Held back one and a quarter inches to show the internal rail.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 cbtexplained.com. All Rights Reserved.