Published at Thursday, 06 September 2018. Storage Shed. By Marta Woodward.
This step takes several adjustments to make sure the overhangs and reveals are all equal attach the panel to the rails, using one and five-eighths inch screws install one screw at each rail end and in the center the trim screws will increase the attachment strength when the trim Is installed remember that there is a one and a quarter inch reveal, so the screws will need to be at least an inch and a half from the panel edges be careful not to install them so far in from the edge that the trim boards will not Cover them, the third step is to build the main operable door.
It is built similar to the secondary door, except that the front panel overhangs on all sides. This allows it to overlap the secondary door to create a more weather, tight, fit and finish use the same screw sizes and placements that you did on the other door. You made the main door front. Panel. Overhangs are different from the secondary door that you built previously.
Once the reveals are equal, you can install the door hinges. Install 6-inch gate hinges using three inch exterior screws. Remember that the door rails are 1 and a quarter inches from the door. Edges, so you must angle the screws that are not over the door rails so that they hit the door rails. The bolt of the hinges should be centered on the gap between the door and the shed trim.
The three sides that touch the shed walls and floor will have an overhang of one and 1/4 inches. The side that touches the secondary door will have an overhang of one and a half inch after the two doors are made. You should lay them next to each other and verify the overhangs and overall sizes. The fourth step is to attach the door trim pieces cut out the trim pieces and check that they will fit together on the front of the doors, make sure that the screws are located so that they incur into the door rails behind the siding use a screw. At each end of each trim piece and then spaced evenly at 12 to 16 inches apart, any trim pieces in the center of the door panel will need to have their screws angled so that they hit the inner door.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 cbtexplained.com. All Rights Reserved.