Published at Sunday, 02 September 2018. Storage Bench. By Shelley Andrews.
I believe these are wrought at around five inches wide. Using this built-in stop block, I will now cut all the legs to the final emissions. Eight simple cuts. I will now cut all the rails for the bottom of the bench to link. This is what the legs of tie into these first two cuts are the long rails, and these next four will be the short rails. The goal will go on the end of each of the benches. Now I have my rails, the sides and the ends. I have all my legs and I have my six boards for the top of the bench to sit on. I'm not gonna show you all the pocket.
Now you will see following the same pattern of the cut side goes down. I will cut the two sides that have not been cut yet I will repeat this for all the legs and I think I ended up repeating this step. Two more time, I'm not going to show you all these cuts, but you get the point now. He will repeat the same steps with top part of the bench I'll be trimming off each side twice with the final cut of the four going to final dimension. This is the same thing I did on the table, as you may remember, and this is the final cut that will get us down to our final dimensions.
Benches to go under my new kitchen table. You know that one thing I'm really big on doing is trimming off these edges of the board time. We used the way I'm turning these boards. After I cut it is the cut edge is going down, so it will go in the same motion all the way. Through there you see the cutters went down, and now we cut the next side and then we will set down to the side putting the cutters down again.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 cbtexplained.com. All Rights Reserved.