Published at Saturday, 01 September 2018. Storage Bench. By Lottie Osborne.
The long stretchers are a little bit longer than the capacity of my miter station, so I clamp them together and I can cut them to make sure that they were all the same size. I don't really love working with two by fours because they tend to be wet knotty and it's just hard to find straight boards, But with a little patience you can find some decent stock and to get good joints on the board.
I like to rip them down to three and a half inches wide to three inches wide and remove that rounded edge. You also get some really nice, kindling or shims from these off cuts to get the two by twos. I make the same initial cut. To get one straight edge, Then I set the fence to an inch and a half, and I make two cuts to get two pieces out of each of the two by fours. You get nice clean edges, But man they are sharp so to round over the edges quickly. I clamped a hand sander down to my bench and I ran each edge over the sander a couple times.
Any content, trademark’s, or other material that might be found on the cbtexplained.com website that is not cbtexplained.com’s property remains the copyright of its respective owner/s. In no way does cbtexplained.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 cbtexplained.com. All Rights Reserved.